Page 1 of 1

KPT 3's Spheroid Designer (preview window)

Posted: Sun Nov 26, 2017 9:42 pm
by pnjnca
Dug out my ancient KPT3 Spheroid Designer:

Enabled mutations and hit the preview window for a preview of the most current mutation. Is there any way to constrain that current mutation shown in preview so it is the one that actually applies to the image?

As I click to leave the preview window the mutations continue to evolve so the actual apply is never the same as was being shown in the preview.

It's been so darned long I cannot recall if it was even possible to constrain, and am fast running out of keystroke combinations to try.