--Way to simulate a "warm" lighting effect with Co

ColorWasher specific discussions
Montanan

--Way to simulate a "warm" lighting effect with Co

Postby Montanan » Thu Oct 07, 2004 8:30 pm

Hello,

i have colorwasher plugin, and use it with irfanview.

Is their a way I can not only colorwash an image, but also add a "warming effect filter" to the image at the same time?

I have messed around some with color temperature settings, but it seems to through off the auto features of colorwasher. Just not sure of correct procedure.

thanks,

Montanan

HaraldHeim
Plugin Guru
Plugin Guru
Posts: 3331
Joined: Fri Mar 08, 2002 1:00 am
Location: The Plugin Site
Contact:

Postby HaraldHeim » Fri Oct 08, 2004 11:35 am

To color correct a photo and add a color effect at the same time, you have to do the color correction at first.

Then you select the Target color box and change its color from gray to a slightly colored "gray" by using the three sliders below. Doing that with the Color Temp. color model is a bit difficult, because when you switch to it, it doesn't keep the gray tone. So better use the RGB or HSL sliders.


Return to “ColorWasher”

Who is online

Users browsing this forum: No registered users and 2 guests