Page 1 of 1

Problem installing ColorWasher demo for PSCS2 on Mac OSX

Posted: Sun Oct 30, 2005 2:27 am
by cbfreeborn
Everytime I attempt to install the demo version of ColorWasher for Photoshop CS2 on Mac OSX (10.4.2), I get a generic message that there were errors during the installation. I've tried installing into a separate folder under the Photoshop only plug-ins folder, but no luck. Any suggestions as to what might be going wrong?

Thanks// Chris

Posted: Sun Oct 30, 2005 2:00 pm
by HaraldHeim
What exactly did the error messages say?

It could be that the file wasn't downloaded completely. I get email from people occasionally that had such a problem. If that is the case, please try downloading again.

Posted: Sun Oct 30, 2005 8:34 pm
by cbfreeborn
Hmmm ... must have been some transient problem: I tried again today after the system had been restarted and the installation worked just fine. The original error message was very generic - it appeared at the top of the installation dialog box immediately after the installation step was launched and in a single simple sentence stated there has been an error with the installation and to try again.

Thanks// Chris