Can't run FocalBlade in Batch in Photoshop CS2

FocalBlade specific discussions
Post Reply
Steve Ferguson

Can't run FocalBlade in Batch in Photoshop CS2

Post by Steve Ferguson »

I can't use FocalBlade 1.04 in a CS2 action. I always have to hit "OK" to get FocalBlade to proceed. Is there any way to get FocalBlade to work in an action?

Thanks

HaraldHeim
Plugin Guru
Plugin Guru
Posts: 3360
Joined: Fri Mar 08, 2002 1:00 am
Location: The Plugin Site
Contact:

Post by HaraldHeim »

Please read the Cloak Mode chapter in the manual.

gstepic

hopefully if I hit ok it will still work

Post by gstepic »

I have another post on this subject, but what I would like to do is have it where I just hit an assigned function key to perform an action set up for various sharpening situations. This way I can quickly go through individual files and apply the appropriate sharpening. If I have to hit ok then this will still work, although it slows things down some because of an extra step.

From what I read the cloak mode is good if I want to apply same settings to all photos in a folder.

HaraldHeim
Plugin Guru
Plugin Guru
Posts: 3360
Joined: Fri Mar 08, 2002 1:00 am
Location: The Plugin Site
Contact:

Post by HaraldHeim »

Yes, you can't store the sharpening settings of FocalBlade in the actions themselves. You need to save these settings as presets in FocalBlade and open them again when you need it.

A future version of FocalBlade will support saving the parameters directly in actions.

Post Reply