Page 1 of 1

IP5300 resolution & Focal Blade

Posted: Sat Dec 04, 2010 1:48 pm
by tonyt
I am new here! I am trialling Focal Blade. It asks for my printer resolution. My manual says 9600X2400!
What single figure should I enter?
Many thanks
tonyt :-?

Posted: Sat Dec 04, 2010 4:44 pm
by HaraldHeim
FocalBlade asks for the print resolution and not the printer resolution!

You should set the print resolution in FocalBlade that you have selected (or will select later) in the printer driver window. So this figure does not refer to the maximum resolution of your printer. Often you are not printing at maximum resolution.

As some printer driver dialogs do not display any figures but rather terms like "Normal" or "Best", these terms also appear when you select the printer type.

If you are still not sure, choosing 2400 dpi should be fine for printing photos.