Page 1 of 1

Another B/W Styler question

Posted: Wed Mar 14, 2007 3:15 pm
by ejk
When using the B/W styler, is there a way to isolate one color to an area?
When trying this on an image, If there are a number of similar colors they all show up. How can I avoid this and only have the one area I choose turn on?

Posted: Thu Mar 15, 2007 4:54 pm
by HaraldHeim
The Selective B/W Mode in B/W Styler lets you add back color to an image area with a certain color.

However, some images have colors that are very similar, so it is very hard or impossible to seperate them without manual masking. In such cases you need to create a selection in your image application before running B/W Styler.