Adobe Photoshop Brushes

Comments and discussions about Adobe Photoshop
rachnasingh
Plugin Master
Plugin Master
Posts: 27
Joined: Tue Sep 10, 2002 5:31 am

Adobe Photoshop Brushes

Postby rachnasingh » Tue Oct 11, 2005 5:36 pm

If I want to start a line with 22 pixels and end the line with 11 pixels ie when i try to make a vein in the leaf or want to make a line that ends in a point how can i do it in adobe photoshop cs

bgoodman4
Plugin Novice
Plugin Novice
Posts: 2
Joined: Wed Nov 09, 2005 5:08 pm

Postby bgoodman4 » Wed Nov 09, 2005 5:13 pm

Draw the line. Using the wand select it. Go to Transform, select Distort. Grab one of the corners and move it as much as you want.

PS:
If the line is attached to an object remove (clear) a small section close to the end of the area you want to distort so that the Wand selects only the area you want to distort.

rachnasingh
Plugin Master
Plugin Master
Posts: 27
Joined: Tue Sep 10, 2002 5:31 am

Postby rachnasingh » Wed Nov 09, 2005 5:15 pm

bgoodman4 wrote:Draw the line. Using the wand select it. Go to Transform, select Distort. Grab one of the corners and move it as much as you want.

PS:
If the line is attached to an object remove (clear) a small section close to the end of the area you want to distort.


but in adobe the lolours will get lost or smuged

bgoodman4
Plugin Novice
Plugin Novice
Posts: 2
Joined: Wed Nov 09, 2005 5:08 pm

Postby bgoodman4 » Fri Nov 11, 2005 6:27 am

Did you try it?

I just tried it with a green and red line. No problem at all except for some slight softening of the colour at the edges. And I went from a line that was 7 MM thick, to one that was 7MM thick at one end and 70 MM at the other. You are talking about a much smaller distortion (at least you were in your first post) so the apparent softening would be substantially less in your case.

I tried this using the distort and the skew functions and as I said, no problem. I did this on version 7 but I cannot imagine that it would be any different in CS.

jelbel
Plugin Novice
Plugin Novice
Posts: 2
Joined: Tue Nov 22, 2005 2:49 pm

Postby jelbel » Tue Nov 22, 2005 2:54 pm

I had a look in photoshop and this can be achieved by
going into BRUSHES...SHAPE DYNAMICS....and in
CONTROLS..tick FADE. it can be further angled or
rounded as one wishes.


Return to “Photoshop”

Who is online

Users browsing this forum: No registered users and 5 guests